+86-28-87559167
Mobile: +8613551050780
MODEL: SPXO11-10M-100M
Low Phase Noise (-160dBc/Hz@1kHz)
Integrated low noise OCXO & PLL
Wide Frequency Range (up to 160MHz)
MODEL: SPXO11-10M-100M
FEATURES
Low Phase Noise (-160dBc/Hz@1kHz)
Integrated low noise OCXO & PLL
Wide Frequency Range (up to 160MHz)
ELECTRONIC PARAMETERS
Parameters | Conditions | Min. | Typ | Max. | Units | |
Nominal Frequency | － | 100.000 | MHz | |||
Supply voltage | － | 11.4 | 12 | 12.6 | V | |
Package size | － | 50×50×16 | mm | |||
Power consumption | During warm up | － | － | 4.8 | Watts | |
Steady state @ 25℃ | － | － | 2.4 | Watts | ||
Freq. stability vs. load | Without REF, RL±5％ | － | － | ±2 | ppb | |
Freq. stability vs. supply voltage | Without REF, VDD±5％ | － | － | ±2 | ppb | |
Initial tolerance | Without REF | － | － | ±0.5 | ppm | |
Lock indication level | @ locked | 3.0 | － | － | V | |
Aging | per day | After 30 days of continues operation Without REF | － | － | ±5 | ppb |
per 1st year | － | － | ±0.5 | ppm | ||
per 10 years | － | － | ±0.3 | ppm | ||
Operating temperature range | － | -40 | － | 70 | ℃ | |
Output wave | － | SINWAVE | － | |||
Output power | VDD=12V | 8 | 10 | 12 | dBm | |
Output load | － | － | 50 | － | Ω | |
Harmonics | － | － | － | -30 | dBc | |
Spurious | － | － | － | -70 | dBc | |
Phase noise | @ 10Hz offset | @ 100MHz | － | － | -100 | dBc/Hz |
@ 100Hz offset | － | － | -130 | dBc/Hz | ||
@ 1kHz offset | － | － | -160 | dBc/Hz | ||
@ 10kHz offset | － | － | -170 | dBc/Hz | ||
@ 100kHz offset | － | － | -170 | dBc/Hz | ||
Requirement on REF
Parameters | Conditions | Min. | Typ | Max. | Units |
Nominal Frequency | － | 10.000 | MHz | ||
Initial tolerance | － | － | － | ±0.5 | ppm |
Signal power | 50Ωload | 0 | － | 5 | dBm |
Phase noise | @ 10Hz | － | － | -130 | dBc/Hz |
PACKAGE
PIN DESCRIPTION
REF: REF Signal Input
ALM: Lock Indication
G: Ground Case
+V: Supply Voltage
OUT: RF Output
TYPICAL SSB PHASE NOISE
Notes: Consult factory about other frequencies or special requirement.
+86-28-87559167
Mobile: +8613551050780
